Cores rebuilt to factory clearances
Houston remanufacturing for reciprocating and rotary-screw compressors - OEM tolerances, parts, and field support for HVAC and refrigeration contractors.
Four lanes for contractor change-outs
Compressors built to order, plus the consumables and technical answers that keep a change-out moving.
Reciprocating compressors
Carrier, Copeland, Trane, and York recip cores torn down to bare castings, machined back to factory dimensions, and rebuilt to run like new.
Rotary screw compressors
Carrier, Trane, and York rotary screw units built for larger-tonnage systems where a clean remanufactured core matters.
Parts and supplies
Oil (1 and 5 gal), acid reducer, spring mount kits, service valves, crankcase heaters, and unloaders shipped alongside your unit.
Technical support
Model ID, application help, and field questions - so your techs can finish the install without guessing.
Houston shop floor since 2004
Family-owned in Houston and focused on three things: building solid compressors, answering contractors clearly, and giving the technical support it takes to get the job done.
We rebuild every compressor to last and to make install and maintenance easier in the field. Owner David Brown works from 7205 Belgold St.
From bare casting to tagged unit
Every compressor follows the same measured path - from the first core we built to the one leaving today.
Teardown
Pistons, rods, valve plates, bearing heads, and sleeves come off down to bare castings for inspection.
Inspect and measure
Bores, crank journals, and mains are measured to the thousandth; the model is verified against the unit.
Machine and recondition
Surfaces return to tolerance and gasket faces are trued. Anything outside spec is machined or replaced.
Reassemble to spec
New gaskets, bearings, and wear parts go in as the compressor is rebuilt to factory clearances.
Run-test
Amperage on each leg and oil pressure are checked so the unit proves itself before it leaves.
Finish and ship
Painted, tagged, and packed so a heavy compressor arrives clean and ready to set.
Marks we leave on every rebuild
Small shop details that show up on pump-downs, oil changes, and the next service call.
Built to exacting factory clearances for longer compressor life.
Every valve plate valve is set by hand for stronger pump-downs.
On Carrier 06D and Copeland, the side drain plug is drilled and tapped.
Connection gaskets ship with the compressor so the install is not shorted.
Ledger notes contractors keep
Practical shop habits that keep electrical boxes clean and unloaders oriented for the job.
Electrical box mounting threads are chased and fitted with new screws.
Unloaders, correct oil, and end-bell orientation set the way the install needs.
Finished compressors are run and checked before they leave the building.
Family-owned Belgold Street floor serving contractors since 2004.
Send the model - we call you back
Have the nameplate handy if you can. Leave a number and David will follow up about the right compressor for the application.
Request callback